I was looking into implementing an Inertial Navigation System for an Android phone, which I realise is hard given the accelerometer accuracy, and constant fluctuation of readings.

To start with, I set the phone on a flat surface and sampled 1000 accelerometer readings in the X and Y directions (parallel to the table, so no gravity acting in these directions). I then averaged these readings and used this value to calibrate the phone (subtracting this value from each subsequent reading).

I then tested the system by again placing it on the table and sampling 5000 accelerometer readings in the X and Y directions. I would expect, given the calibration, that these accelerations should add up to 0 (roughly) in each direction. However, this is not the case, and the total acceleration over 5000 iterations is nowhere near 0 (averaging around 10 on each axis).

I realise without seeing my code this might be difficult to answer but in a more general sense...

Is this simply an example of how inaccurate the accelerometer readings are on a mobile phone (HTC Desire S), or is it more likely that I&#39;ve made some errors in my coding?


All Calibration Solutions on Gang of Coders

Total of 1 Calibration Solutions

Android accelerometer accuracy (Inertial navigation)