Upgrade package without upgrading dependencies using pip?

PythonVirtualenvPip

Python Problem Overview


I'm using pip and virtualenv for my python application. I would like to upgrade to a new version of the application without touching the dependencies. When I use pip install -U, it tries to upgrade all the packages, and even uninstalls and re-installs the same version of a dependency package when there isn't a new version available.

I also tried pip install -U --no-deps but that seems equivalent to a regular install instead of an upgrade. Is there a combination of flags that will do what I want?

Python Solutions


Solution 1 - Python

Overview:

  • Install new packages without upgrading installed ones: pip install (without -U)
  • Upgrade only packages that are outdated according to requirements: pip install --upgrade --upgrade-strategy only-if-needed (default in new versions)
  • Upgrade package and all dependencies to latest version: pip install --upgrade --upgrade-strategy eager (default in old versions)
  • Install or upgrade listed packages without touching dependencies: --no-deps

UPDATE (thanks to @Jether's comment): If you're using the latest version of pip, then updating dependencies only when necessary is now the default behavior, and you don't need to do anything special! The answer below outlines the steps for older versions of pip (which also works for newer versions if you want to be portable).

If you really want to not touch dependencies, then indeed the way to go is

pip install -U --no-deps mypackage

But I think what you'll usually want is to not upgrade dependencies unless it's required. In that case you can use:

pip install --upgrade --upgrade-strategy only-if-needed mypackage

This only updates requirements if the package requires a newer version than is installed.

Solution 2 - Python

I just tried on my virtualenv project and pip install -U --no-deps mypackage seems to work just fine. It just download mypackage and nothing else. What's your set up like?

Solution 3 - Python

You're right. I thought that when I added --no-deps it had neglected to uninstall the existing version. But I tried it again and see there's no issue:

$ pip install -U --no-deps myproj
Downloading/unpacking myproj
  Downloading myproj-1.0-trunk.31072.tar.gz (43Kb): 43Kb downloaded
  Running setup.py egg_info for package myproj
Installing collected packages: myproj
  Found existing installation: myproj 1.0-trunk.31053
    Uninstalling myproj:
      Successfully uninstalled myproj
  Running setup.py install for myproj
Successfully installed myproj
Cleaning up...

Attributions

All content for this solution is sourced from the original question on Stackoverflow.

The content on this page is licensed under the Attribution-ShareAlike 4.0 International (CC BY-SA 4.0) license.

Content TypeOriginal AuthorOriginal Content on Stackoverflow
QuestionAmy GView Question on Stackoverflow
Solution 1 - PythonMarkView Answer on Stackoverflow
Solution 2 - PythonY.H WongView Answer on Stackoverflow
Solution 3 - PythonAmy GView Answer on Stackoverflow