Is there any way I can define a variable in LaTeX?
VariablesLatexVariables Problem Overview
In LaTeX, how can I define a string variable whose content is used instead of the variable in the compiled PDF?
Let's say I'm writing a tech doc on a software and I want to define the package name in the preamble or somewhere so that if its name changes, I don't have to replace it in a lot of places but only in one place.
Variables Solutions
Solution 1 - Variables
add the following to you preamble:
\newcommand{\newCommandName}{text to insert}
Then you can just use \newCommandName{} in the text
For more info on \newcommand, see e.g. wikibooks
Example:
\documentclass{article}
\newcommand\x{30}
\begin{document}
\x
\end{document}
Output:
30
Solution 2 - Variables
Use \def command:
\def \variable {Something that's better to use as a variable}
Be aware that \def overrides preexisting macros without any warnings and therefore can cause various subtle errors. To overcome this either use namespaced variables like my_var or fall back to \newcommand, \renewcommand commands instead.
Solution 3 - Variables
For variables describing distances, you would use \newlength (and manipulate the values with \setlength, \addlength, \settoheight, \settolength and \settodepth).
Similarly you have access to \newcounter for things like section and figure numbers which should increment throughout the document. I've used this one in the past to provide code samples that were numbered separatly of other figures...
Also of note is \makebox which allows you to store a bit of laid-out document for later re-use (and for use with \settolength...).
Solution 4 - Variables
If you want to use \newcommand, you can also include \usepackage{xspace} and define command by \newcommand{\newCommandName}{text to insert\xspace}.
This can allow you to just use \newCommandName rather than \newCommandName{}.
For more detail, http://www.math.tamu.edu/~harold.boas/courses/math696/why-macros.html
Solution 5 - Variables
I think you probably want to use a token list for this purpose:
to set up the token list
\newtoks\packagename
to assign the name:
\packagename={New Name for the package}
to put the name into your output:
\the\packagename.
Solution 6 - Variables
This works for me: \newcommand{\variablename}{the text}
For eg: \newcommand\m{100}
So when you type " \m\ is my mark " in the source code,
the pdf output displays as :
100 is my mark